5.3.- USER PROFILE
This profile is identified with the symbol at the top of the screen (Figure 21).
Figure 21: Screen of the CVM-C11 with the user profile.
This profile displays the screens selected in the programming menu (“6.14.- SELECTING THE OPERATION
PROFILE”).
Note: If you have not selected the display of any screen, the device will restart and display the
Phase-Neutral Voltage screen by default.
The voltage and current harmonics are also displayed, up to the 31st order harmonic, for each of the
lines, L1, L2 and L3 (“5.4.- HARMONICS.”).
5.4.- HARMONICS
The device can display the voltage and current harmonics, up to the 31st order harmonic, for each one
of the lines, L1, L2 and L3.
The display of these can be deactivated using the programming menu (“6.20.- ACTIVATING THE HAR
MONICS DISPLAY SCREEN.”).
The harmonics display screens are displayed in the Analyzer and User operating profiles, by pressing
the key after the last screen of the profile.
Harmonics are displayed as shown on Figure 22.
Harmonic order
Harmonic value
Harmonic type
Figure 22: CVM-C11 harmonics screen.
35
Instruction Manual
CVM-C11
To Next Page
Loading...
