Circutor CVM-C11-ITF-IN-485-ICT2 - 6�25�7�- Contact Status; 6�26�- Programming the Alarm Relay 2; 6�27�- Programming Alarm 3 (Digital Output T1)

6.25.7.- CONTACT STATUS
The status of relay contacts is selected on this screen.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
The key jumps between the possible options.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 50:Configuration values: Contact status.
Contact status
Possible values
NO Normally open contact.
NC Normally closed contact.
Press key to access the next programming step.
6.26.- PROGRAMMING THE ALARM RELAY 2
In this step, all the values corresponding to alarm relay 2 are programmed.
They are programmed as in the case of alarm relay 1, see “6.25.- PROGRAMMING THE ALARM RELAY 1”.
6.27.- PROGRAMMING ALARM 3 DIGITAL OUTPUT T1
All values for digital output T1 are programmed on this screen.
The variable code is selected on this screen, depending on Table 43, Table 44 and Table 51, which will
control digital output T1.
62
CVM-C11
Instruction Manual