6.36.- MODBUS PROTOCOL: NUMBER OF STOP BITS
Note: Screen visible if the Modbus protocol has been programmed, “6.31.- RS-485 COMMUNICATIONS:
PROTOCOL”.
The number of Stop bits of Modbus communications are programmed on this screen.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
The key jumps between the possible options.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 60:Configuration values: No of stop bits.
Modbus: No of stop bits
Possible values
1 bits
2 bits
Press key to access the next programming step.
6.37.- BACnet PROTOCOL: BAUD RATE
Note: Screen visible if the BACnet protocol has been programmed, “6.31.- RS-485 COMMUNICATIONS:
PROTOCOL”.
The baud rate of BACnet communications is programmed on this screen.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
The key jumps between the possible options.
To validate the data, press for 3 seconds and the icon will disappear from the display.
70
CVM-C11
Instruction Manual
To Next Page
Loading...
