6.31.- RS-485 COMMUNICATIONS: PROTOCOL
The RS-485 communications protocol is selected on this screen.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
The key jumps between the possible options.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 56:Configuration values: RS-485: Protocol.
RS-485: Protocol
Possible values
Modbus
BACnet
Note: The device will restart after exiting the setup menu if the RS-485 communications parameters
have been modified.
Press key to access the next programming step.
6.32.- MODBUS PROTOCOL: BAUD RATE
Note: Screen visible if the Modbus protocol has been programmed, “6.31.- RS-485 COMMUNICATIONS:
PROTOCOL”.
The baud rate of Modbus communications is programmed on this screen.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
The key jumps between the possible options.
To validate the data, press for 3 seconds and the icon will disappear from the display.
67
Instruction Manual
CVM-C11
To Next Page
Loading...
