6.39.- BACnet PROTOCOL: MAC ADDRESS
Note: Screen visible if the BACnet protocol has been programmed, “6.31.- RS-485 COMMUNICATIONS:
PROTOCOL”.
The MAC address is programmed on this screen.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
To enter or modify the value, press the key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values.
The programmed value will be deleted if the entered value is higher than the maximum programming
value.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 63:Configuration values: BACnet, MAC address.
BACnet: MAC address
Minimum value 0
Maximum value 255
Press key to access the next programming step.
6.40.- LOCKING THE PROGRAMMING
This screen is for protecting the data configured in the programming menu.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
72
CVM-C11
Instruction Manual
To Next Page
Loading...
