Circutor CVM-C11-ITF-IN-485-ICT2 - 6�8�- Measurement Convention; 6�9�- Type of Installation

6.8.- MEASUREMENT CONVENTION
You can select the measurement convention of the device from this screen.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
The key jumps between the possible options.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 24:Configuration values: Measurement convention.
Measurement convention
Possible values
Cir Circutor measurement convention.
IEC IEC 61557-12 measurement convention.
IEEE IEEE 1459 measurement convention.
Press key to access the next programming step.
6.9.- TYPE OF INSTALLATION
The type of installation is selected on this screen.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
The key jumps between the possible options.
To validate the data, press for 3 seconds and the icon will disappear from the display.
43
Instruction Manual
CVM-C11