The key jumps between the possible options.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 64:Configuration values: Locking the programming.
Locking the programming
Possible values
unIoc When you enter the programming menu you can view and modify the
programming.
Ioc When you enter the programming you can view the programming but not
modify it. Icon indicates the locking status.
Press key to access the next programming step.
6.40.1.- PASSWORD
Note: Screen visible if the programming lock has been activated, Ioc, “6.40.- LOCKING THE PROGRAM
MING”.
On this screen you enter the password for locking and unlocking the programming.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
To enter or modify the value, press the key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values.
The programmed value will be deleted if the entered value is higher than the maximum programming
value.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 65:Configuration values: Password.
Password
Default value 1234
This value may only be modified through communications. See “7.3.8.18. Password configuration.”
Press the key to exit the setup menu.
Note: The device will restart after exiting the setup menu if the RS-485 communications parameters
have been modified.
73
Instruction Manual
CVM-C11
To Next Page
Loading...
