Configuration values
Table 25:Configuration values: Type of installation.
Type of installation
Possible values
4-3Ph Three-phase network measurement with a 4-wire connection.
3-3Ph Three-phase network measurement with a 3-wire connection.
3-AroN Three-phase network measurement with a 3-wire connection and
transformers with an ARON connection.
3-2Ph Two-phase network measurement with a 3-wire connection.
2-2Ph Single-phase network measurement, phase to phase, with a 2-wire
connection.
2-1Ph Single-phase network measurement, phase to neutral, with a 2-wire
connection.
Press key to access the next programming step.
6.10.- TYPE OF INTEGRATION OF THE MAXIMUM DEMAND
In this screen, the type of integration to be used for the calculation of the maximum demand is
selected. See “4.1.2.- MAXIMUM DEMAND”.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
The key jumps between the possible options.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 26:Configuration values: Type of integration of the maximum demand.
Type of integration of the maximum demand
Possible values
SIide Sliding window
timed Fixed window
Note: When modifying the type of integration, the device restarts the calculation of the maximum
demand.
Press key to access the next programming step.
44
CVM-C11
Instruction Manual
To Next Page
Loading...
