Cisco 2431 - IAD Router - Operations for Use with Class C Flash File System; File Operations for Class C Flash File System

B-8
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
OL-4306-03
Appendix B Formatting the Flash Memory
File and Directory Operations
00000150: AC27C720 3C018001 AC30C724 3C018001 ,'G <... ,0G$ <...
00000160: AC31C728 3C018001 AC32C72C 3C018001 ,1G( <... ,2G, <...
--More-- q
Operations for Use with Class C Flash File System
The following file and directory operations are useful for flash memory formatted with a Class C flash
file system.
File Operations for Class C Flash File System
Copying Files
To copy files to another location, enter the copy {flash: | slot0:} command.
Note slot0 is not supported on the IAD2435 IAD.
The following example shows sample output for copying a Cisco IOS file from an external flash memory
to internal flash memory:
Router# copy slot0:c2430-is-mz.tmp flash:
Destination filename [c2430-is-mz.tmp]?
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
6458584 bytes copied in 202.940 secs (31973 bytes/sec)
The following example shows sample output for copying a configuration file to the startup configuration
in internal flash memory (
flash:):
Router# copy flash:my-config1 startup-config
Destination filename [startup-config]?
[OK]
517 bytes copied in 4.188 secs (129 bytes/sec)
The following example shows sample output for copying a configuration file to the running
configuration in internal flash memory (
flash:):
Router# copy flash:my-config2 running-config
Destination filename [running-config]?
709 bytes copied in 0.72 secs
Displaying the Contents of Flash Memory
To display the contents (directories and files) of flash memory formatted with a Class C flash file
system, use the dir{flash: | slot0:} or show {flash: | slot0:} command.
The following examples show sample outputs for displaying the contents of an external flash memory
with a Class C flash file system:
Router# dir slot0:
Directory of slot0:/