CHAPTER
2-1
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
OL-4306-03
2
Using the setup Command Facility
This chapter describes how to use the setup command facility to configure your Cisco integrated access
device (IAD). The setup command facility prompts you to enter information needed to start a router
functioning quickly. The facility steps you through a basic configuration, including LAN and WAN
interfaces.
This chapter presents the following major topics:
• Before Powering On Your Cisco IAD, page 2-1
• The setup Command Facility, page 2-2
• Configuring Global Parameters, page 2-2
• Configuring Controller and Interface Parameters, page 2-5
• Completing the Configuration, page 2-13
If you prefer to configure the router manually or if you wish to configure a module or interface that is
not included in the setup command facility, proceed to “
Chapter 3, “Configuring with the
Command-Line Interface,” for step-by-step instructions.
If you prefer to configure the router by using AutoInstall, see the Using AutoInstall to Remotely
Configure Cisco Networking Devices document.
Before Powering On Your Cisco IAD
Before you power on your Cisco IAD and begin to use the setup command facility, follow these steps:
Step 1 Set up the hardware as described in the hardware installation documents for your Cisco IAD.
Step 2 Configure your PC terminal emulation program for 9600 baud, 8 data bits, no parity, and 1 stop bit.
Step 3 Determine which network protocols you are supporting.
Step 4 Determine the following for each network protocol:
• Addressing plan
• Which WAN protocols you will run on each interface (for example, Frame Relay [FR], High-Level
Data Link Control [HDLC], X.25, and so on)
To Next Page
Loading...
Need help?
General
