Cisco 2431 - IAD Router User Manual

3-3
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
OL-4306-03
Chapter 3 Configuring with the Command-Line Interface
Configuring the Hostname and Password
Verifying the Hostname and Password
To verify that you configured the correct hostname and password, follow these steps:
Step 1 Enter the show config command:
Router(config)# show config
Using 1888 out of 126968 bytes
!
version XX.X
.
.
.
!
hostname IAD2430
!
enable secret 5 $1$60L4$X2JYOwoDc0.kqa1loO/w8/
.
.
.
Check the hostname and encrypted password displayed near the top of the command output.
Step 2 Exit global configuration mode and attempt to reenter it, using the new enable password:
Router# exit
.
.
.
Router con0 is now available
Press RETURN to get started.
Router> enable
Step 5
line console
Example:
Router(config)# line console 0
Enters line configuration mode to configure the console
port. When you enter line configuration mode, the
prompt changes to
Router(config-line)#.
Step 6
exec-timeout
Example:
Router(config-line)# exec-timeout 0 0
If no input is detected during the interval, the EXEC
facility resumes the current connection. If no
connections exist, the EXEC facility returns the terminal
to the idle state and disconnects the incoming session.
Note To specify no timeout, enter the
exec-timeout
0 0 command.
Step 7
exit
Example:
Router(config-line)# exit
Exits to global configuration mode.
Step 8
end
Example:
Router(config-if)# end
Returns you to privileged EXEC mode.
Command or Action Purpose

Cisco 2431 - IAD Router Specifications

General

Brand	Cisco
Model	2431 - IAD Router
Category	Network Hardware
Language	English