C-1
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
OL-4306-03
APPENDIX
C
Using the ROM Monitor
This appendix describes the ROM monitor (also called the bootstrap program), which is the firmware
that runs when you power on or restart the Cisco
IAD2430 series integrated access device (IAD). During
normal operation, the ROM monitor helps to initialize the processor hardware and boot the operating
system software. You can also use the ROM monitor to help you isolate or rule out hardware problems
that you encounter while installing your router.
This appendix contains the following sections:
• Entering the ROM Monitor Mode, page C-1
• ROM Monitor Commands, page C-2
• Command Descriptions, page C-3
• Configuration Register, page C-6
• Console Download, page C-7
• Debug Commands, page C-8
• Exiting the ROM Monitor, page C-9
Entering the ROM Monitor Mode
To use the ROM monitor, you must be using a terminal or PC that is connected to the router over the
console port.
Perform these steps to configure the router to boot up in ROM monitor mode the next time it is rebooted.
SUMMARY STEPS
1. enable
2. configure terminal
3. config-register value
4. exit
5. reload
To Next Page
Loading...
Need help?
General
