Cisco 2431 - IAD Router User Manual

2-6
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
OL-4306-03
Chapter 2 Using the setup Command Facility
Configuring Controller and Interface Parameters
Fast Ethernet WAN Interface Configuration
This section provides sample steps and configuration for the Fast Ethernet WAN interface.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface type/number
4. ip address ip address/subnet mask
5. no shutdown
6. end
DETAILED STEPS
Command or Action Purpose
Step 1
enable
Example:
Router# enable
Enters privileged EXEC mode.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
interface type/number
Example:
Router(config)# interface fastethernet 2
Router(config-if)#
Enters the configuration mode for a Fast Ethernet WAN
interface on the router.
Step 4
ip address ip address/subnet mask
Example:
Router(config-if)# ip address 192.168.12.2
255.255.255.0
Router(config-if)#
Sets the IP address and subnet mask for the specified Fast
Ethernet interface.

Cisco 2431 - IAD Router Specifications

General

Brand	Cisco
Model	2431 - IAD Router
Category	Network Hardware
Language	English