Index
IN-3
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
OL-4306-03
L
linking PBX users with E&M trunk lines example 4-7
M
meminfo command C-9
N
network modules
2-6, 2-7
configuring
serial interface 2-7
P
parameters
2-5
pass-through 3-17, 3-18
privileged EXEC command mode 1-7
PSTN gateway access using FXO connection (PLAR
mode)
4-9
PSTN gateway access using FXO connection
example
4-8
R
recovering boot and system images C-4
reset command C-3
ROM monitor
commands C-2 to C-3
debug commands C-8, C-9
entering C-1
exiting C-9
S
saving configuration changes 3-38
setup command 2-2
show config command 3-3
slot/port identification
digital voice ports 3-14
stack command C-8
synchronous serial interface
configuring 3-20
sysret command C-9
T
T1 (FT1) CSU/DSU WAN interface (WIC-2T card),
configuring
3-24
T1 WAN interface with analog FXS and FXO user
interfaces
1-10
T1 WAN interface with analog FXS user interfaces 1-9
T1 WAN interface with T1 interface to PBX 1-10
tables
Clock Rate Settings for 1-Port/2-Port Serial WAN
Interface Card in Synchronous Mode
3-23
Clock Rate Settings for 2-Port Synchronous Serial
WAN Interface Card
3-23
Clock Rate Settings for 4-Port Synchronous Serial
Interface Card
3-23
Common Command Modes 1-7
Half-Duplex Timer Commands 3-22
TDM cross-connect 3-16
TFTP download
See also console download
U
user EXEC command mode 1-7
V
virtual configuration register C-6
voice over IP
configuration examples 4-4
configuring 4-2
To Next Page
Loading...
