Contents
iv
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
OL-4306-03
Dedicated Mode 2-12
Completing the Configuration 2-13
CHAPTER
3 Configuring with the Command-Line Interface 3-1
Configuring the Hostname and Password 3-2
Verifying the Hostname and Password 3-3
Configuring Fast Ethernet Interfaces 3-4
Configuring Network Clock 3-5
Configuring T1/E1 Interfaces 3-7
Configuring Channel Groups on T1/E1 to Support Data 3-8
Configuring Channel Groups on T1/E1 to Support Data Under SHDSL Controller 3-10
Configuring Digital Voice on T1/E1 3-11
Configuring Switch Types for ISDN PRI Q.931 Support 3-12
Configuring DS0 Groups for CAS 3-14
Configuring TDM Cross-Connect 3-16
Configuring TDM to TDM 3-17
Configuring TDM to Analog Voice Port 3-18
Configuring TDM to Physical Serial Interface 3-18
Configuring a WIC-1DSU-T1/E1 Serial WAN Interface Card 3-20
Configuring a WIC-1T or WIC-2T Serial WAN Interface Card 3-24
Configuring a VIC2-2FXO or VIC2-4FXO Voice Interface Card 3-24
Configuring a VIC2-2FXS or VIC2-4FXS Voice Interface Card 3-26
Configuring ATM T1-WAN Ports 3-28
Verifying Your ATM Interface Configuration 3-31
Configuring 1-Port ADSL/SHDSL WAN Interface Card 3-32
Configuration Tasks 3-32
Configuring the ADSL/SHDSL Port on the ADSL and SHDSL WAN Interface Card 3-32
Verifying ATM Configuration 3-35
Configuring a VIC2-2BRI-NT/TE Card 3-36
Saving Configuration Changes 3-38
CHAPTER
4 Configuring Voice over IP 4-1
Prerequisites 4-1
Configuring the Voice Interface 4-2
VoIP Configuration Examples 4-4
FXS-to-FXS Connection 4-4
Configuration for IAD-1 4-5
Configuration for Router RLB-w 4-5
To Next Page
Loading...
