Cisco 7600-SIP-400 - SPA Interface Processor 400 - A P P E N D I X E Cisco 7606-S DC Power Supply Configurations; Cisco 7606-S V01 Configuration with Two 4500 W DC Power Supplies

E-2
Cisco 7600 Series Router Installation Guide
OL-4503-26
Appendix E Cisco 7606-S DC Power Supply Configurations
Cisco 7606-S V01 Configuration with Two 4500 W DC Power Supplies
Cisco 7606-S V01 Configuration with Two 4500 W DC Power
Supplies
Note This configuration requires you to remove the old booster brackets (Part Number 700-23386-01 ) and
replace them with the slim brackets (Part Number 700- 26979-01). To do this, proceed as follows:
Step 1 Remove the power supplies as described in Removing PWR-2700-DC Power Supply from a Cisco
7606-S Router, page 5-19.
Step 2 Remove the two screws (Part Number 48-2030-01) securing the bracket (Part Number 700-23386-01) at
the top slot and remove the bracket. See
Figure E-1.
Step 3 Remove the two screws (Part Number 48-2030-01) securing the bracket (Part Number 700-23386-01) at
the lower slot and remove the bracket. See
Figure E-1.
Step 4 Use the screws (Part Number 48-2030-01) removed in Step 1 to install the slim bracket (Part Number
700-26979-01) at the top slot. See
Figure E-2.
Step 5 Use the screws (Part Number 48-2030-01) removed in Step 2 to install the slim bracket (Part Number
700-26979-01) at the bottom slot. See
Figure E-2.
Step 6 Install the 4500 W DC in the upper and lower shelves as described in Installing a PWR-4500-DC Power
Supply in a Cisco 7606-S Router, page 5-61.
Figure E-1 Removing Fat Brackets
253051
Cisco 7600
Series