2-2
Cisco 7600 Series Router Installation Guide
OL-4503-26
Chapter 2 Preparing for Installation
Safety
Safety
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available.
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Read the installation instructions before connecting the system to the power source.
Warning
This product requires short-circuit (overcurrent) protection, to be provided as part of the building
installation. Install only in accordance with national and local wiring regulations.
Supported Line Cards on 7600 Chassis
Ta b l e 2-1 List of Supported Line Cards on 7600 Chasis
Product Product Description
7600-ES20-GE3C 7600 ES20 Line Card, 20xGE SFP with DFC 3C
7600-ES20-GE3CXL 7600 ES20 Line Card, 20xGE SFP with DFC 3CXL
7600-ES20-10G3C 7600 ES20 Line Card, 2x10GE XFP with DFC 3C
7600-ES20-10G3CXL 7600 ES20 Line Card, 2x10GE XFP with DFC 3CXL
7600-ES+20G3C 7600 ES+ Line Card, 20xGE SFP with DFC 3C
7600-ES+20G3CXL 7600 ES+ Line Card, 20xGE SFP with DFC 3CXL
7600-ES+2TG3C 7600 ES+ Line Card, 2x10GE XFP with DFC 3C
7600-ES+2TG3CXL 7600 ES+ Line Card, 2x10GE XFP with DFC 3CXL
7600-ES+40G3C 7600 ES+ Line Card, 40xGE SFP with DFC 3C
7600-ES+40G3CXL 7600 ES+ Line Card, 40xGE SFP with DFC 3CXL
7600-ES+4TG3C 7600 ES+ Line Card, 4x10GE XFP with DFC 3C
7600-ES+4TG3CXL 7600 ES+ Line Card, 4x10GE XFP with DFC 3CXL
7600-SIP-200 Cisco 7600 Series SPA Interface Processor-200
7600-SIP-400 Cisco 7600 Series SPA Interface Processor-400
To Next Page
Loading...
Need help?
General
