EasyManua.ls Logo

Cisco 7600-SIP-400 - SPA Interface Processor 400 - Cisco 7600 Series Router Components; Cisco 7606 Router; Cisco 7606-S Router; Cisco 7609 Router

Cisco 7600-SIP-400 - SPA Interface Processor 400
324 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1-19
Cisco 7600 Series Router Installation Guide
OL-4503-26
Chapter 1 Product Overview
Cisco 7600 Series Router Components
PEM, page 1-32
Fan Assembly
The system fan assembly, located in the chassis, provides cooling air for the supervisor engine and
the
switching modules. Figure 1-13 (Cisco 7603 router), Figure 1-14 (Cisco 7603-S router), Figure 1-15
(Cisoc 7604 router), Figure 1-16 (Cisco 7606 router), Figure 1-17 (Cisco 7606-S router), and
Figure 1-18 (Cisco 7609 router and Cisco 7609-S router) show the direction of airflow into and out of
the router. Sensors on the supervisor engine monitor the internal air temperatures. If the air temperature
exceeds a preset threshold, the environmental monitor displays warning messages.
If an individual fan within the assembly fails, the FAN STATUS LED turns red. To replace a fan
assembly, see the
“Removing and Replacing the Fan Assembly” section on page 5-119.
Note Refer to the Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide for
information on environmental monitoring.
Figure 1-13 Cisco 7603 Router Internal Airflow

Table of Contents

Related product manuals