Contents
vii
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
OL11954-01
Adding Phones with Cisco Unified Communications Manager
Administration
2-16
Adding Phones with BAT 2-16
Using Cisco Unified IP Phones with Different Protocols 2-17
Converting a New Phone from SCCP to SIP 2-17
Converting an In-Use Phone from SCCP to SIP 2-18
Converting an In-Use Phone from SIP to SCCP 2-18
Deploying a Phone in an SCCP and SIP Environment 2-19
Determining the MAC Address of a Cisco Unified IP Phone 2-19
CHAPTER
3 Setting Up the Cisco Unified IP Phone 3-1
Before You Begin 3-2
Network Requirements 3-2
Cisco Unified Communications Manager Configuration 3-3
Understanding the Cisco Unified IP Phones 7906G and 7911G Components 3-3
Network and Access Ports 3-4
Handset 3-4
Speaker 3-4
Monitor Mode 3-5
Group Listen Mode 3-5
Headset 3-6
Audio Quality Subjective to User 3-7
Connecting a Headset 3-7
Using External Devices with Your Cisco Unified IP Phone 3-8
Installing the Cisco Unified IP Phone 3-9
Mounting the Phone to a Wall 3-15
Verifying the Phone Startup Process 3-16
Configuring Startup Network Settings 3-17
Configuring Security on the Cisco Unified IP Phone 3-17
To Next Page
Loading...
