Chapter 1 An Overview of the Cisco Unified IP Phone
Overview of Configuring and Installing Cisco Unified IP Phones
1-34
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.0
OL-11953-01
5. Configure these network settings on
the phone by choosing Settings >
Network Configuration.
To enable DHCP:
• Set DHCP Enabled to Ye s
• To use an alternate TFTP server, set
Alternate TFTP Server to Yes
Enter IP address for TFTP Server 1
To disable DHCP:
• Set DHCP Enabled to No
• Enter static IP address for phone
• Enter subnet mask
• Enter default router IP addresses
• Enter domain name where phone
resides
• Set Alternate TFTP Server to Yes
Enter IP address for TFTP Server 1
Using DHCP—The IP address
is automatically assigned and
the Cisco Unified IP Phone is
directed to a TFTP Server.
Note Consult with the
network administrator
if you need to assign
an alternative TFTP
server instead of using
the TFTP server
assigned by DHCP.
Without DHCP—You must
configure the IP address,
TFTP server, subnet mask,
domain name, and default
router locally on the phone.
See the “Configuring
Startup Network Settings”
section on page 3-18.
See the “Network
Configuration Menu”
section on page 4-7.
6. Set up security on the phone. Provides protection against
data tampering threats and
identity theft of phones.
See the “Configuring
Security on the Cisco
Unified IP Phone” section
on page 3-18.
7. Make calls with the Cisco Unified IP
Phone.
Verifies that the phone and
features work correctly.
Refer to Cisco Unified IP
Phone 7961G/7961G-GE
and 7941G/7941G-GE
Phone Guide.
8. Provide information to end users about
how to use their phones and how to
configure their phone options.
Ensures that users have
adequate information to
successfully use their Cisco
Unified IP Phones.
See Appendix A,
“Providing Information to
Users Via a Website.”
Table 1-7 Checklist for Installing the Cisco
Unified IP Phone 7961G/7961G-GE/7941G/7941G-GE (continued)
Task Purpose For More Information
To Next Page
Loading...
