Cisco ASA 5512-X Cli Configuration Guide

1-27
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Inspection of Basic Internet Protocols
IPv6 Inspection
Information about IPv6 Inspection
IPv6 inspection lets you selectively log or drop IPv6 traffic based on the extension header. In addition,
IPv6 inspection can check conformance to RFC 2460 for type and order of extension headers in IPv6
packets.
Default Settings for IPv6 Inspection
If you enable IPv6 inspection and do not specify an inspection policy map, then the default IPv6
inspection policy map is used, and the following actions are taken:
• Allows only known IPv6 extension headers
• Enforces the order of IPv6 extension headers as defined in the RFC 2460 specification
If you create an inspection policy map, the above actions are taken by default unless you explicitly
disable them.
(Optional) Configuring an IPv6 Inspection Policy Map
To identify extension headers to drop or log, and/or to disable packet verification, create an IPv6
inspection policy map to be used by the service policy.

Cisco ASA 5512-X Specifications

General

Firewall Throughput	1.2 Gbps
VPN Throughput	200 Mbps
Maximum VPN Peers	250
Integrated IPS	Yes
IPS Throughput	250 Mbps
RAM	4 GB
Power Supply	AC, 100-240V
Security Contexts	2 (Standard), 50 (with Security Contexts license)
Interfaces	6 x Gigabit Ethernet
Dimensions (H x W x D)	1.75 x 17.5 x 14.5 inches
Weight	16 lbs