Cisco ASA 5512-X Cli Configuration Guide

CHAPTER
1-1
Cisco ASA Series CLI Configuration Guide
1
Adding an EtherType Access List
This chapter describes how to configure EtherType access lists and includes the following sections:
• Information About EtherType Access Lists, page 1-1
• Licensing Requirements for EtherType Access Lists, page 1-1
• Guidelines and Limitations, page 1-2
• Default Settings, page 1-2
• Configuring EtherType Access Lists, page 1-2
• Monitoring EtherType Access Lists, page 1-4
• What to Do Next, page 1-4
• Configuration Examples for EtherType Access Lists, page 1-5
• Feature History for EtherType Access Lists, page 1-5
Information About EtherType Access Lists
An EtherType access list is made up of one or more Access Control Entries (ACEs) that specify an
EtherType. An EtherType rule controls any EtherType identified by a 16-bit hexadecimal number, as well
as selected traffic types. See the “Supported EtherTypes and Other Traffic” section on page 1-5 for more
information.
For information about creating an access rule with the EtherType access list, see Chapter 1, “Configuring
Access Rules.”
Licensing Requirements for EtherType Access Lists
The following table shows the licensing requirements for this feature:
Model License Requirement
All models Base License.

Cisco ASA 5512-X Specifications

General

Firewall Throughput	1.2 Gbps
VPN Throughput	200 Mbps
Maximum VPN Peers	250
Integrated IPS	Yes
IPS Throughput	250 Mbps
RAM	4 GB
Power Supply	AC, 100-240V
Security Contexts	2 (Standard), 50 (with Security Contexts license)
Interfaces	6 x Gigabit Ethernet
Dimensions (H x W x D)	1.75 x 17.5 x 14.5 inches
Weight	16 lbs