EasyManuals Logo

Cisco ASA 5512-X Cli Configuration Guide

Cisco ASA 5512-X
2164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #662 background imageLoading...
Page #662 background image
1-30
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring OSPF
Configuring OSPFv3
Configuring OSPFv3 Timers
You can set LSA arrival, LSA pacing, and throttling timers for OSPFv3.
To set the minimum interval at which the ASA accepts the same LSA from OSPFv3 neighbors, perform
the following steps:
Detailed Steps
To configure LSA flood packet pacing, perform the following steps:
Detailed Steps
Command Purpose
Step 1
ipv6 router ospf process-id
Example:
hostname(config-if)# ipv6 router ospf 1
Enables an OSPFv3 routing process and enters IPv6 router
configuration mode.
The process-id argument is an internally used identifier for this
routing process, is locally assigned, and can be any positive
integer from 1 to 65535. This ID does not have to match the ID on
any other device; it is for internal administrative use only. You can
use a maximum of two processes.
Step 2
timers lsa arrival milliseconds
Example:
hostname(config-rtr)# timers lsa arrival
2000
Sets the minimum interval at which the ASA accepts the same
LSA from OSPF neighbors.
The milliseconds argument specifies the minimum delay in
milliseconds that must pass between acceptance of the same LSA
arriving from neighbors. The range is from 0 to 6,000,000
milliseconds. The default is 1000 milliseconds.
Command Purpose
Step 1
ipv6 router ospf process-id
Example:
hostname(config-if)# ipv6 router ospf 1
Enables an OSPFv3 routing process and enters IPv6 router
configuration mode.
The process-id argument is an internally used identifier for this
routing process, is locally assigned, and can be any positive
integer from 1 to 65535. This ID does not have to match the ID on
any other device; it is for internal administrative use only. You can
use a maximum of two processes.
Step 2
timers pacing flood milliseconds
Example:
hostname(config-rtr)# timers lsa flood 20
Configures LSA flood packet pacing.
The milliseconds argument specifies the time in milliseconds at
which LSAs in the flooding queue are paced in between updates.
The configurable range is from 5 to 100 milliseconds. The default
value is 33 milliseconds.

Table of Contents

Other manuals for Cisco ASA 5512-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASA 5512-X and is the answer not in the manual?

Cisco ASA 5512-X Specifications

General IconGeneral
Firewall Throughput1.2 Gbps
VPN Throughput200 Mbps
Maximum VPN Peers250
Integrated IPSYes
IPS Throughput250 Mbps
RAM4 GB
Power SupplyAC, 100-240V
Security Contexts2 (Standard), 50 (with Security Contexts license)
Interfaces6 x Gigabit Ethernet
Dimensions (H x W x D)1.75 x 17.5 x 14.5 inches
Weight16 lbs

Related product manuals