1-10
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring RIP
Customizing RIP
Note Before you can enable RIP route authentication, you must enable RIP.
To enable RIP authentication on an interface, perform the following steps:
Detailed Steps
. Restarting the RIP Process
To remove the entire RIP configuration, enter the following command:
Command Purpose
Step 1
router rip as-num
Example:
hostname(config)# router rip 2
Creates the RIP routing process and enters router configuration
mode for this RIP process.
The as-num argument is the autonomous system number of the
RIP routing process.
Step 2
interface phy_if
Example:
hostname(config)# interface phy_if
Enters interface configuration mode for the interface on which
you are configuring RIP message authentication.
Step 3
rip authentication mode {text | md5}
Example:
hostname(config-if)# rip authentication
mode md5
Sets the authentication mode. By default, text authentication is
used. We recommend that you use MD5 authentication.
Step 4
rip authentication key key key-id key-id
Example:
hostname(config-if)# rip authentication
key cisco key-id 200
Configures the authentication key used by the MD5 algorithm.
The key argument can include up to 16 characters.
The key-id argument is a number from 0 to 255.
Command Purpose
clear rip pid {process | redistribution |
counters [neighbor [neighbor-interface]
[neighbor-id]]}
Example:
hostname(config)# clear rip
Removes the entire RIP configuration that you have enabled. After the
configuration is cleared, you must reconfigure RIP again using the router
rip command.
To Next Page
Loading...
Need help?
General
