1-16
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Network Admission Control
Changing Global NAC Framework Settings
Detailed Steps
Command Purpose
Step 1
global
Switches to global configuration mode.
Step 2
eou port port_number
Example:
hostname(config)# eou port 62445
hostname(config)#
The default port number is 21862. This command
changes the port number (on the client endpoint)
used for EAP over UDP communication with
posture agents.
port_number must match the port number
configured on the CTA. Enter a value in the range
1024 to 65535.
Changes the port number for EAP over UDP
communication to 62445.
Step 3
(Optional)
no eou port
Example:
hostname(config)# no eou port
hostname(config)#
Changes the port number to its default value.
Step 4
eou timeout retransmit seconds
Example:
hostname(config)# eou timeout retransmit 6
hostname(config)#
Changes the retransmission retry timer. When the
ASA sends an EAP over UDP message to the remote
host, it waits for a response. If it fails to receive a
response within n seconds, it resends the EAP over
UDP message. By default, the retransmission timer
is 3 seconds.
seconds is a value in the range 1 to 60.
Changes the retransmission timer to 6 seconds.
Step 5
(Optional)
no eou timeout retransmit
Example:
hostname(config)# no eou timeout retransmit
hostname(config)#
Changes the retransmission retry timer to its default
value.
Step 6
eou max-retry retries
Example:
hostname(config)# eou max-retry 1
hostname(config)#
Changes retransmission retries. When the ASA
sends an EAP over UDP message to the remote host,
it waits for a response. If it fails to receive a
response, it resends the EAP over UDP message. By
default, it retries up to 3 times.
retries is a value in the range 1 to 3.
Limits the number of EAP over UDP
retransmissions to 1.
To Next Page
Loading...
Need help?
General
