1-15
Cisco ASA Series CLI Configuration Guide
Chapter 1 Starting Interface Configuration (ASA 5510 and Higher)
Starting Interface Configuration (ASA 5510 and Higher)
Step 4 For each in-use interface that you want to add to a redundant or EtherChannel interface, cut and paste
all commands under the interface command to the end of the interface configuration section for use in
creating your new logical interfaces. The only exceptions are the following commands, which should
stay with the physical interface configuration:
• media-type
• speed
• duplex
• flowcontrol
Note You can only add physical interfaces to an EtherChannel or redundant interface; you cannot have
VLANs configured for the physical interfaces.
Be sure to match the above values for all interfaces in a given EtherChannel or redundant
interface. Note that the duplex setting for an EtherChannel interface must be Full or Auto.
For example, you have the following interface configuration. The bolded commands are the ones we
want to use with three new EtherChannel interfaces, and that you should cut and paste to the end of the
interface section.
interface GigabitEthernet0/0
nameif outside
security-level 0
ip address 10.86.194.225 255.255.255.0
no shutdown
!
interface GigabitEthernet0/1
nameif inside
security-level 100
ip address 192.168.1.3 255.255.255.0
no shutdown
!
interface GigabitEthernet0/2
shutdown
no nameif
no security-level
no ip address
!
interface GigabitEthernet0/3
shutdown
no nameif
no security-level
no ip address
!
interface GigabitEthernet0/4
shutdown
no nameif
no security-level
no ip address
!
interface GigabitEthernet0/5
shutdown
no nameif
no security-level
no ip address
!
interface Management0/0
nameif mgmt
To Next Page
Loading...
Need help?
General
