Cisco ASA 5512-X Cli Configuration Guide

1-22
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring OSPF
Configuring OSPFv3
ipv6 ospf hello-interval seconds
Example:
hostname(config-if)# interface
GigabitEthernet3/2.200
vlan 200
nameif outside
security-level 100
ip address 10.20.200.30 255.255.255.0
standby 10.20.200.31
ipv6 address 3001::1/64 standby 3001::8
ipv6 address 6001::1/64 standby 6001::8
ipv6 enable
ospf priority 255
ipv6 ospf cost 100
ipv6 ospf 100 area 10 instance 200
ipv6 ospf hello-interval 15
Specifies the interval in seconds between hello packets sent on the
interface. The value must be the same for all nodes on a specific
network and can range from 1 to 65535. The default interval is 10
seconds for Ethernet interfaces and 30 seconds for non-broadcast
interfaces.
ipv6 ospf mtu-ignore
Example:
hostname(config-if)# interface
GigabitEthernet3/2.200
vlan 200
nameif outside
security-level 100
ip address 10.20.200.30 255.255.255.0
standby 10.20.200.31
ipv6 address 3001::1/64 standby 3001::8
ipv6 address 6001::1/64 standby 6001::8
ipv6 enable
ospf priority 255
ipv6 ospf cost 100
ipv6 ospf 100 area 10 instance 200
ipv6 ospf mtu-ignore
Disables the OSPF MTU mismatch detection when DBD packets
are received. OSPF MTU mismatch detection is enabled by
default.
ipv6 ospf network {broadcast |
point-to-point non-broadcast}
Example:
hostname(config-if)# interface
GigabitEthernet3/2.200
vlan 200
nameif outside
security-level 100
ip address 10.20.200.30 255.255.255.0
standby 10.20.200.31
ipv6 address 3001::1/64 standby 3001::8
ipv6 address 6001::1/64 standby 6001::8
ipv6 enable
ospf priority 255
ipv6 ospf cost 100
ipv6 ospf 100 area 10 instance 200
ipv6 ospf network point-to-point
non-broadcast
Sets the OSPF network type to a type other than the default, which
depends on the network type. The point-to-point non-broadcast
keyword sets the network type to point-to-point non-broadcast.
The broadcast keyword sets the network type to broadcast.
Command Purpose

Cisco ASA 5512-X Specifications

General

Firewall Throughput	1.2 Gbps
VPN Throughput	200 Mbps
Maximum VPN Peers	250
Integrated IPS	Yes
IPS Throughput	250 Mbps
RAM	4 GB
Power Supply	AC, 100-240V
Security Contexts	2 (Standard), 50 (with Security Contexts license)
Interfaces	6 x Gigabit Ethernet
Dimensions (H x W x D)	1.75 x 17.5 x 14.5 inches
Weight	16 lbs