Cisco ASR 5000 Series

Per-service Session Thresholds
Per-SGSN Service Thresholds ▀
Cisco ASR 5000 Series Thresholding Configuration Guide ▄
OL-25552-02
121
Per-SGSN Service Thresholds
Per-SGSN service thresholds generate alerts or alarms based on the total number of attached subscribers facilitated by
any SGSN service configured on the system during the specified polling interval.
Alerts or alarms are triggered for sessions per-SGSN service based on the following rules:
Enter condition: Actual total number of attached subscribers > or = High Threshold
Clear condition: Actual total number of attached subscribers < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end of the
polling interval.
Configuring Per-SGSN Service Thresholds
Use the following example to configure the per-SGSN service thresholds:
configure
threshold per-service-sgsn-sessions <high_thresh> [ clear <low_thresh> ]
threshold poll per-service-sgsn-sessions interval <time>
threshold monitoring subscriber
end