Cisco ASR 5000 Series Thresholding Configuration Guide

Cisco ASR 5000 Series Thresholding Configuration Guide ▄
OL-25552-02
77
Chapter 11
HA Service Thresholds
HA Service thresholds generate alerts or alarms for the average number of calls setup. A threshold can be configured to
report this information for an entire context or for an individual HA service. Thresholds can also be configured for
registration reply, re-registration reply and de-registration reply errors for individual HA services.
Alerts or alarms are triggered for these HA thresholds based on the following rules:
Enter condition: Actual average of call setups or actual number of errors > or = High Threshold
Clear condition: Actual average of call setups or actual number of errors < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm is not generated until the end of the polling
interval.
The following table describes the possible methods for configuring HA Service thresholds:
Method
Description
To configure, go to
section:
Context-
Level
This threshold keeps track of the average number of call setups for all HA services in a
context. When the actual average of call setups per polling period meets or exceeds the
set high threshold an alert or alarm is set.
Context-Level HA
Service Thresholds
HA
Service-
Level
HA services send and receive registration messages. The thresholds in the HA Service-
Level can be configured to monitor thresholds for registration reply, re-registration reply,
and de-registration reply errors.
HA Service-Level HA
Service Thresholds

Cisco ASR 5000 Series Specifications

General

Brand	Cisco
Model	ASR 5000 Series
Category	Network Router
Language	English