Cisco ASR 5000 Series

Subscriber Thresholds
Total Subscriber Thresholds ▀
Cisco ASR 5000 Series Thresholding Configuration Guide ▄
OL-25552-02
139
Total Subscriber Thresholds
Total subscriber thresholds generate alerts or alarms based on the total number of subscriber sessions (active and
dormant) facilitated by the system during the specified polling interval.
Alerts or alarms are triggered for subscriber totals based on the following rules:
Enter condition: Actual total number of subscriber sessions > or = High Threshold
Clear condition: Actual total number of subscriber sessions < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end of the
polling interval.
This section provides instructions for configuring total subscriber thresholding. These instructions assume that you are
at the prompt for the Global Configuration mode:
Configuring Total Subscriber Thresholds
Use the following example to configure the total subscriber thresholds:
configure
threshold subscriber total <high_thresh> [ clear <low_thresh> ]
threshold poll total-subscriber interval <time>
threshold monitoring subscriber
end