Port Utilization Thresholds
Receive Port Utilization Thresholds ▀
Cisco ASR 5000 Series Thresholding Configuration Guide ▄
Receive Port Utilization Thresholds
Receive port utilization thresholds generate alerts or alarms based on the utilization percentage of each configured port
in relation to data received during the specified polling interval. This threshold is configured on a per-port basis.
Alerts or alarms are triggered for receive port utilization based on the following rules:
Enter condition: Actual percent utilization of a port for received data > or = High Threshold
Clear condition: Actual percent utilization of a port for received data < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end of the
polling interval.
Configuring Receive Port Utilization Thresholds
Use the following example to configure the polling interval over which to measure receive port utilization
configure
threshold poll port-rx-utilization interval <seconds>
port <port-type> <slot#/port#>
threshold rx-utilization <high_thresh_%> [ clear <low_thresh_%> ]
threshold monitoring
end
To Next Page
Loading...
