Cisco ASR 5000 Series Thresholding Configuration Guide

Call Setup Thresholds
RP Setup Failure Rate Thresholds ▀
Cisco ASR 5000 Series Thresholding Configuration Guide ▄
OL-25552-02
37
RP Setup Failure Rate Thresholds
RP setup failure rate thresholds generate alerts or alarms based on the rate of call setup failures experienced by the
system during the specified polling interval. The failure rate is the percentage of failures as determined by number of
Registration Request Messages rejected divided by the total number of Registration Request Messages received.
Alerts or alarms are triggered for RP setup failure rates based on the following rules:
Enter condition: Actual number of call setup failures > or = High Threshold
Clear condition: Actual number of call setup failures < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end of the
polling interval.
Configuring RP Setup Failure Rate Thresholds
Use the following example for configuring RP setup failure rate thresholding:
configure
threshold rp-setup-fail-rate <high_thresh> [ clear <low_thresh> ]
threshold poll rp-setup-fail-rate interval <time>
threshold monitoring call-setup
end

Cisco ASR 5000 Series Specifications

General

Brand	Cisco
Model	ASR 5000 Series
Category	Network Router
Language	English