Cisco ASR 5000 Series Thresholding Configuration Guide

FNG Thresholds
▀ Configuring FNG Thresholds
▄ Cisco ASR 5000 Series Thresholding Configuration Guide
74
OL-25552-02
Configuring FNG Thresholds
Use the following configuration example to configure FNG threshold monitoring:
configure
[ no | default ] threshold monitoring fng-service
[ default ] threshold fng-current-sessions <high_thresh> [ clear <low_thresh> ]
[ default ] threshold poll fng-current-sessions interval <time>
end
Usage thresholds are provided for monitoring the overall FNG usage on an ASR 5000 chassis. These commands are
used to monitor the total number of FNG sessions, both active and inactive, over an entire chassis.
In the commands above, <high_thresh> configures the total number of FNG sessions on an ASR 5000 chassis, both
active and inactive. <high_thresh> is any integer from 0 to 300000. There is no default, but 0 means that there is no
threshold monitoring.
The clear <low_thresh> command clears any percentage of the number of sessions being monitored using the
<high_thresh> variable defined above. <low_thresh> is any integer from 0 to 300000.
The following example configures a monitoring threshold of 300000 active and inactive FNG sessions on an ASR 5000
chassis:
threshold fng-current-sessions 300000
This turns out to be too many, so the following command clears 100000:
threshold fng-current-sessions 300000 clear 100000

Cisco ASR 5000 Series Specifications

General

Brand	Cisco
Model	ASR 5000 Series
Category	Network Router
Language	English