Cisco ASR 901 User Manual

1-91
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
police (percent)
Command Default All Supported Platforms
The default bc and be values are 4 ms.
Command Modes Policy-map class configuration (config-pmap-c)
Command History
action (Optional) Action to take on packets. Specify one of the following keywords:
All Supported Platforms
• drop—Drops the packet.
• set-clp-transmit—Sets the ATM Cell Loss Priority (CLP) bit from 0
to 1 on the ATM cell and sends the packet with the ATM CLP bit set to 1.
• set-dscp-transmit new-dscp—Sets the IP differentiated services code
point (DSCP) value and sends the packet with the new IP DSCP value
setting.
• set-frde-transmit—Sets the Frame Relay discard eligible (DE) bit from
0 to 1 on the Frame Relay frame and sends the packet with the DE bit set
to 1.
• set-prec-transmit new-prec—Sets the IP precedence and sends the
packet with the new IP precedence value setting.
• transmit—Sends the packet with no alteration.
• policed-dscp-transmit—(Exceed and violate action only). Changes the
DSCP value per the policed DSCP map and sends the packet.
• set-cos-inner-transmit value—Sets the inner class of service field as a
policing action for a bridged frame on the Enhanced FlexWAN module,
and when using bridging features on SPAs.
• set-cos-transmit value—Sets the packet cost of service (CoS) value and
sends the packet.
• set-mpls-exposition-transmit—Sets the Multiprotocol Label
Switching (MPLS) experimental bits from 0 to 7 and sends the packet
with the new MPLS experimental bit value setting.
• set-mpls-topmost-transmit—Sets the MPLS experimental bits on the
topmost label and sends the packet.
Release Modification
15.1(2)SNG Support for this command was introduced on the Cisco ASR 901 router.

Cisco ASR 901 Specifications

General

Brand	Cisco
Model	ASR 901
Category	Network Router
Language	English