Cisco ASR 901

1-3
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 Using Command-Line Interface
How to Find Command Options
Router(config)# interface gigabitethernet ?
<1-9> GigabitEthernet interface number
Router(config)# interface gigabitethernet 0/1
Router(config-if)#
Enter interface configuration mode by
specifying the Gigabit Ethernet
interface that you want to configure
using the interface gigabitethernet
global configuration command.
Enter a ? to display what you must
enter next on the command line. In
this example, you must enter an
interface number from 1 to 9 in the
format module-number/port-number.
You are in interface configuration
mode when the prompt changes to
Router(config-if)#.
Router(config-if)#?
Interface configuration commands:
access-expression Build a bridge boolean access expression
arp Set arp type (arpa, probe, snap) or timeout
backup Modify backup parameters
bandwidth Set bandwidth informational parameter
bgp-policy Apply policy propogated by bgp community string
bridge-group Transparent bridging interface parameters
carrier-delay Specify delay for interface transitions
cdp CDP interface subcommands
channel-group Etherchannel/port bundling configuration
clns CLNS interface subcommands
cmns OSI CMNS
custom-queue-list Assign a custom queue list to an interface
decnet Interface DECnet config commands
default Set a command to its defaults
delay Specify interface throughput delay
description Interface specific description
dlsw DLSw interface subcommands
dspu Down Stream PU
exit Exit from interface configuration mode
fair-queue Enable Fair Queuing on an Interface
flowcontrol Configure flow operation.
fras DLC Switch Interface Command
help Description of the interactive help system
hold-queue Set hold queue depth
ip Interface Internet Protocol config commands
ipx Novell/IPX interface subcommands
isis IS-IS commands
iso-igrp ISO-IGRP interface subcommands
.
.
.
Router(config-if)#
Enter a ? to display a list of all the
interface configuration commands
available for the Gigabit Ethernet
interface.
Table 1-2 How to Find Command Options (continued)
Command Comment