Cisco ASR 901

1-85
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
network-clock synchronization automatic
network-clock synchronization automatic
To enable G.781 based automatic clock selection process, use the network-clock synchronization
automatic command. Use the no form of the command to disable the G.781 based automatic clock
selection process.
network-clock synchronization automatic
no network-clock synchronization automatic
Command Modes Global configuration
Command History
Usage Guidelines The network-clock synchronization automatic command enables the G.781 based automatic clock
selection process. G.781 is the ITU-T Recommendation that specifies the synchronization layer
functions.
Examples The following example shows how to enable the G.781 based automatic clock selection process.
Router(config)# network-clock synchronization automatic
Related Commands
Release Modification
15.1(2)SNG Support for this command was introduced on the Cisco ASR 901 router.
Command Description
network-clock eec Configures the clocking system hardware with the desired parameters
network-clock
synchronization ssm
option
Configures the router to work in a synchronized network mode as described
in G.781