Cisco ASR 901

1-121
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
service instance
service instance
To configure an Ethernet service instance, use the service instance command in Layer 2 VPN
configuration mode. To disable this configuration, use the no form of this command.
service instance id service-type
no service instance id service-type
Syntax Description
Command Default None
Command Modes Layer 2 VPN configuration (config-l2vpn)
Command History
Usage Guidelines You must provision a Multiprotocol Label Switching (MPLS) pseudowire before configuring an Ethernet
service instance in Layer 2 VPN configuration mode.
Examples The following example shows how to configure an Ethernet service instance on a Cisco uBR10012
router:
Router(config-l2vpn) # service instance 4095 ethernet
id Service instance ID. Integer from 1 to 4294967295.
service-type Service type for the instance.
Release Modification
15.1(2)SNG Support for this command was introduced on the Cisco ASR 901 router.