1-51
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
interface atm ima
interface atm ima
To configure an ATM IMA group and enter interface configuration mode, use the interface atm ima
global configuration command. If the group does not exist when the command is issued, the command
automatically creates the group.
interface atm slot/imagroup-number
Syntax Description
Defaults The interface includes individual ATM links, but no IMA groups.
Command Modes Global configuration
Command History
Usage Guidelines When a port is configured for IMA functionality, it no longer operates as an individual ATM link.
Specifying ATM links as members of a group using the ima-group interface command does not enable
the group. You must use the interface atm slot/imagroup-number command to create the group.
Examples The following example shows the how to create the IMA group:
Router(config)# interface ATM0/IMA0
Router(config-if)# no ip address
Related Commands
slot Specifies the slot location of the ATM IMA port adapter.
group-number Specifies an IMA group number from 0 to 3. You can create up to four
groups.
Release Modification
15.1(2)SNG Support for this command was introduced on the Cisco ASR 901 router.
Command Description
ima-group Configures the physical links as IMA group members; execute this
interface configuration command for each physical link that you
include in an IMA group.
ima group-id Enables the user to configure the IMA Group ID for the IMA
interface.
interface atm Configures physical links for an ATM interface.
show ima interface atm Displays general and detailed information about IMA groups and the
links they include.
To Next Page
Loading...
Need help?
General
