1-36
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
dmm responder hardware timestamp
dmm responder hardware timestamp
To configure hardware-based timestamping, use the dmm responder hardware timestamp command
in Maintenance End Point (MEP) configuration mode. To disable hardware-based time stamping, use the
no form of this command.
dmm responder hardware timestamp
no dmm responder hardware timestamp
Syntax Description This command has no arguments or keywords.
Command Default Hardware-based timestamping is disabled on the receiver MEP.
Command Modes MEP configuration (config-if-srv-ecfm-mep)
Command History
Examples The following example shows how to configure hardware-based timestamping on the receiver MEP:
Router> enable
Router# configure terminal
Router(config)# interface GigabitEthernet 0/0
Router(config-if)# service instance 1310 ethernet ssvc1310
Router(config-if-srv)# encapsulation dot1q 1310
Router(config-if-srv)# rewrite ingress tag pop 1 symmetric
Router(config-if-srv)# bridge-domain 1310
Router(config-if-srv)# cfm mep domain sdmm mpid 1310
Router(config-if-srv-ecfm-mep)# dmm responder hardware timestamp
Related Commands
Release Modification
15.3(2)S This command was introduced on the Cisco ASR 901 Series Aggregation
Services Router.
Command Description
bridge-domain (service
instance)
Binds a service instance or a MAC tunnel to a bridge domain
instance.
cfm mep domain Configures MEP for a domain.
encapsulation dot1q (service
instance)
Defines the matching criteria to map 802.1Q frames ingress on an
interface to the appropriate service instance
rewrite ingress tag Specifies the encapsulation adjustment to be performed on a frame
ingressing a service instance.
service instance ethernet Configures an Ethernet service instance on an interface.
To Next Page
Loading...
Need help?
General
