1-114
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
rep platform vlb segment
rep platform vlb segment
To configure the VLAN list which forms VLAN load balancing group use the rep platform vlb segment
command. For more information on VLAN Load Balancing, see the Cisco ASR 901 Configuration
Guide.
rep platform vlb segment segment-id vlan {vlan-list | all}
no rep platform vlb
Syntax Description
Command Modes Global Configuration
Command History
Usage Guidelines The rep platform vlb segment command should be issued on all Cisco ASR 901 routers participating
in VLB for a particular segment and should have a matching VLAN list. This vlan list should also match
with the rep block command issued on primary edge port.
Examples The example shows how to configure the VLAN Load Balancing group:
Router(config)# rep platform vlb segment 1 vlan 100-200
Related Commands
segment-id ID of the REP segment. The range is from 1 to 1024.
vlan vlan-list Enter vlan vlan-list to block a single VLAN or a range of VLANs,
all Enter vlan all to block all VLANs. This is the default configuration.
Release Modification
15.1(2)SNG This command was introduced.
Command Description
rep block Configures VLAN load balancing on the primary edge port, identifies the
REP alternate port in one of three ways, and configures the VLANs to be
blocked on the alternate port.
To Next Page
Loading...
Need help?
General
