Cisco ASR 901

1-13
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
asr901-multicast source
asr901-multicast source
To send the multicast packets to the CPU enabling it to transmit register packets to Rendezvous Point
(RP), use the asr901-multicast source command on the interface configuration mode. Use the no form
of the command to disable transmission of multicast packets.
asr901-multicast source
no asr901-multicast source
Syntax Description This command has no arguments or keywords.
Command Default This command is enabled by default.
Command Modes Interface configuration (config-if)#
Command History
Usage Guidelines This command should be enabled on the SVI interface that is connected to the traffic source. After the
configuration, normal Protocol Independent Multicast sparse mode (PIM-SM) register process begins.
Examples This example shows how to enable multicast on a Cisco ASR 901 series router:
Router# configure terminal
Router(config)# interface type number
Router(config-if)# asr901-multicast source
Release Modification
15.4(1)S This command was introduced on the Cisco ASR 901 Series Aggregation
Services Routers.