Cisco ASR 901

1-198
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
synchronous mode
synchronous mode
To configure the ethernet interface to synchronous mode, use the synchronous mode command. Use the
no form of the command to disable the configuration.
synchronous mode
no synchronous mode
Command Default Asynchronous mode.
Command Modes Interface configuration.
Command History
Usage Guidelines This command is applicable to Synchronous Ethernet capable interfaces. The default value is
asynchronous mode.
Examples This example configures the ethernet interface to synchronous mode:
Router(config-if)#synchronous mode
Release Modification
15.1(2)SNG Support for this command was introduced on the Cisco ASR 901 router.