Cisco ASR 901 User Manual

1-126
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
set dscp
set dscp
To mark a packet by setting the differentiated services code point (DSCP) value in the type of service
(ToS) byte, use the set dscp command in policy-map class configuration mode. To remove a previously
set DSCP value, use the no form of this command.
set [ip] dscp {dscp-value}
no set [ip] dscp {dscp-value}
Syntax Description
Command Default Disabled
Command Modes Policy-map class configuration
Command History
ip (Optional) Specifies that the match is for IPv4 packets only. If not used, the
match is on both IPv4 and IPv6 packets.
dscp-value A number from 0 to 63 that sets the DSCP value. The following reserved
keywords can be specified instead of numeric values:
• EF (expedited forwarding)
• AF11 (assured forwarding class AF11)
• AF12 (assured forwarding class AF12)
Release Modification
15.1(2)SNG Support for this command was introduced on the Cisco ASR 901 router.

Cisco ASR 901 Specifications

General

Brand	Cisco
Model	ASR 901
Category	Network Router
Language	English