Cisco ASR 901 User Manual

1-39
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
efd notify g8032
efd notify g8032
To notify G.8032 of failures, use the efd notify g8032 command in the Ethernet CFM service
configuration mode. To remove this configuration, use the no form of this command.
efd notify g8032
no efd notify g8032
Syntax Description
Command Default Monitoring and notifying G.8032 for failures is disabled.
Command Modes Ethernet CFM service configuration (config-ecfm-srv) #
Command History
Usage Guidelines When G8032 ring links are monitored by CFM sessions, use the efd notify g8032 command under CFM
service configuration to notify G8032 of failures, if any.
Examples The following example shows how to use the efd notify g8032 command:
Router # configure terminal
Router(config)# ethernet cfm global
Router(config)# ethernet cfm domain MD4 level 4
Router(config-ecfm)# service 1 evc evc1 vlan 99 direction down
Router(config-ecfm-srv)# continuity-check
Router(config-ecfm-srv)# continuity-check interval 3.3ms
Router(config-ecfm-srv)# offload sampling 6000
Router(config-ecfm-srv)# efd notify g8032
Related Commands
efd notify g8032 Monitors and notifies G.8032 of failures.
Release Modification
15.4(3)S This command was introduced on the Cisco ASR 901 Routers.
Command Description
ethnernet cfm global Enables Ethernet CFM globally on a router.
ethernet cfm domain
level
Defines a CFM maintenance domain at a particular maintenance level.
continuity-check Enables sending and receiving of continuity check messages.
offload sampling Configures the sampling rate for the offloaded CFM session.

Cisco ASR 901 Specifications

General

Brand	Cisco
Model	ASR 901
Category	Network Router
Language	English