Cisco ASR 901

1-70
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
network-clock eec
network-clock eec
To configure the clocking system hardware with the desired parameters, use the network-clock eec
command. Use the no form of the command to disable the clocking system hardware.
network-clock eec {1 | 2}
no network-clock eec {1 | 2}
Syntax Description
Command Modes Global configuration
Command History
Usage Guidelines The network-clock eec command configures the clocking system hardware with the desired parameters.
Examples The following example configures the clocking system hardware with EEC option 1:
Router(config)# network-clock eec 1
Related Commands
1 For option 1, the default value is EEC-Option 1 (2048).
2 For option 2, the default value is EEC-Option 2 (1544).
Release Modification
15.1(2)SNG This command was introduced.
Command Description
network-clock
synchronization ssm
option
Configures the router to work in a synchronized network mode as described
in G.781