Cisco ASR 901 User Manual

1-35
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
dejitter-buffer
dejitter-buffer
To configure the size of the dejitter buffer, use the dejitter-buffer command in CEM configuration mode.
To restore the dejitter buffer to its default size, use the no form of this command.
dejitter-buffer size
no dejitter-buffer
Syntax Description
Defaults The default dejitter-buffer size is 4 milliseconds.
Command Modes CEM configuration
Command History
Examples The following example shows how to specify the size of the dejitter buffer:
Router# config t
Router(config)# interface cem 0/0
Router(config-if)# no ip address
Router(config-if)# cem 0
Router(config-if-cem)# dejitter-buffer 10
Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls
Router(config-if-cem-xconn)# exit
Router(config-if-cem)# exit
Router(config-if)# exit
Router(config)# exit
Related Commands
size Specifies the size of the dejitter buffer in milliseconds. The range is 4 to 500
ms; the default is 4 ms.
Release Modification
15.1(2)SNG Support for this command was introduced on the Cisco ASR 901 router.
Command Description
cem Enters circuit emulation configuration mode.
cem class Applies the CEM interface parameters defined in the given CEM
class name to the circuit.
class cem Configures CEM interface parameters in a class that’s applied to
CEM interfaces together in global configuration mode.

Cisco ASR 901 Specifications

General

Brand	Cisco
Model	ASR 901
Category	Network Router
Language	English