Cisco ASR 901

1-102
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
protocol (ATM)
protocol (ATM)
To configure a static map for an ATM permanent virtual circuit (PVC), switched virtual circuit (SVC),
or virtual circuit (VC) class or to enable Inverse Address Resolution Protocol (ARP) or Inverse ARP
broadcasts on an ATM PVC, use the protocol command in the appropriate mode. To remove a static map
or disable Inverse ARP, use the no form of this command.
protocol protocol {protocol-address [virtual-template] | inarp} [[no] broadcast |
disable-check-subnet | [no] enable-check-subnet]
no protocol protocol {protocol-address [virtual-template] | inarp} [[no] broadcast
disable-check-subnet | [no] enable-check-subnet]
Syntax Description
protocol Choose one of the following values:
• arp—IP ARP
• bridge—bridging
• cdp—Cisco Discovery Protocol
• clns—ISO Connectionless Network Service (CLNS)
• clns_es—ISO CLNS end system
• clns_is—ISO CLNS intermediate system
• cmns—ISO CMNS
• compressedtcp—Compressed TCP
• ip—IP
• llc2—llc2
• pad—packet assembler/disassembler (PAD) links
• ppp—Point-to-Point Protocol carried on the VC
• pppoe—PPP over Ethernet
• pppovlan—PPPoE over vlan
• rsrb—remote source-route bridging
• snapshot—snapshot routing support
protocol-address Destination address that is being mapped to a PVC.
virtual-template (Optional) Specifies parameters that the point-to-point protocol over
ATM (PPPoA) sessions will use.
Note This keyword is valid only for the PPP protocol.