Cisco ASR 901 User Manual

1-131
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
set ip precedence (route-map)
set ip precedence (route-map)
To set the precedence value (and an optional IP number or IP name) in the IP header, use the set ip
precedence command in route-map configuration mode. To leave the precedence value unchanged, use
the no form of this command.
set ip precedence [number | name]
no set ip precedence
Syntax Description
Command Default Disabled
Command Modes Route-map configuration
Command History
Usage Guidelines Table 1-4 lists the values for the number argument and the corresponding name argument for precedence
values in the IP header. They are listed from least to most important.
You can set the precedence using either a number or the corresponding name. Once the IP Precedence
bits are set, other QoS services such as weighted fair queueing (WFQ) and Weighted Random Early
Detection (WRED) then operate on the bit settings.
number | name (Optional) A number or name that sets the precedence bits in the IP header.
The values for the number argument and the corresponding name argument
are listed in Table 1-4 from least to most important.
Release Modification
15.1(2)SNG Support for this command was introduced on the Cisco ASR 901 router.
Table 1-4 Number and Name Values for IP Precedence
Number Name
0 routine
1 priority
2 immediate
3 flash
4 flash-override
5 critical
6 internet
7 network

Cisco ASR 901 Specifications

General

Brand	Cisco
Model	ASR 901
Category	Network Router
Language	English