Cisco ASR 901 User Manual

1-67
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
name
name
To specify the name of a iSCSI target in the target profile on the GGSN, use the name command in iSCSI
interface configuration mode. To remove the IP address configuration, use the no form of the command.
name target_name
no name target_name
Syntax Description
Command Default No default behavior or values.
Command Modes iSCSI interface configuration
Command History
Usage Guidelines Use the name command to specify the name of the SCSI target in an iSCSI target interface profile on
the GGSN.
Examples This example shows how to create Ethernet VLAN 20, name it test20, and add it to the VLAN database:
Router# configure terminal
Router(config)# vlan 20
Router(config-vlan)# name test20
Router(config-vlan)# end
Related Commands
target_name Name of the SCSI target.
Release Modification
15.1(2)SNG Support for this command was introduced on the Cisco ASR 901 router.
Command Description
gprs iscsi Configures the GGSN to use the specified iSCSI profile for
record storage.
ip Specifies the IP address of the target on the SAN.
ip iscsi target-profile Creates an iSCSI interface profile for an SCSI target (or
modifies an existing one), and enters iSCSI interface
configuration mode.
port Specifies the number of the TCP port on which to listen for
iSCSI traffic.

Cisco ASR 901 Specifications

General

Brand	Cisco
Model	ASR 901
Category	Network Router
Language	English