EasyManuals Logo

Cisco Catalyst 2960-XR Configuration Guide

Cisco Catalyst 2960-XR
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #119 background imageLoading...
Page #119 background image
CHAPTER 5
Configuring EtherChannels
Finding Feature Information, page 105
Restrictions for EtherChannels, page 105
Information About EtherChannels, page 106
How to Configure EtherChannels, page 123
Monitoring EtherChannel, PAgP, and LACP Status, page 135
Configuration Examples for Configuring EtherChannels, page 136
Additional References for EtherChannels, page 137
Feature Information for EtherChannels, page 138
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Restrictions for EtherChannels
All ports in an EtherChannel must be assigned to the same VLAN or they must be configured as trunk
ports.
When the ports in an EtherChannel are configured as trunk ports, all the ports must be configured with
the same mode (either Inter-Switch Link [ISL] or IEEE 802.1Q).
Port Aggregation Protocol (PAgP) can be enabled only in single-switch EtherChannel configurations;
PAgP cannnot be enabled on cross-stack EtherChannels.
Catalyst 2960-XR Switch Layer 2 Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29424-01 105

Table of Contents

Other manuals for Cisco Catalyst 2960-XR

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2960-XR and is the answer not in the manual?

Cisco Catalyst 2960-XR Specifications

General IconGeneral
Stacking Bandwidth80 Gbps
Layer SupportLayer 2 and Layer 3
Jumbo Frame Support9198 bytes
RAM512 MB
Input Voltage100-240V AC
ModelCatalyst 2960-XR
Uplink Interfaces4 x 1G SFP or 2 x 10G SFP+
Downlink Interfaces24 or 48 x Gigabit Ethernet ports
Power SupplyInternal
MAC Address Table Size16, 000 entries
PoEAvailable on PoE models
Weight4.5 kg
Featuresenergy efficiency
StackingUp to 8 switches
Operating Temperature0 to 45°C

Related product manuals